How to flash Samsung Stock/Official ROM via Odin

             how to flash Samsung Stock/Official Rom via Odin

FLASHING STOCK ROM VIA ODIN WILL DEFINITELY WIPE YOUR DATA. SO MAKE BACKUP FIRST.

Step 1: Download and install your device driver software on your computer

• Visit Samsung Official Website To Find the device driver software your want to flash.
• Google the driver software of your device. Download and then install it to your computer.

       Once drivers are installed or updated, it is recommended that you restart your computer.

Step 2: Download and Extract the Stock Rom (official or original).

Click Here  to visit the best choice to download stock firmware of Samsung device. OR

Click Here to download from  Samsung Update, XDA  Forum or Google to Find the right firmware of your device

After downloading it (normally a compressed file), you need to extract/unzip it to certain location of your PC. The file types that Odin uses are *.bin,*.tar and *.tar.md5.

                        Find the file you have downloaded and then unzip it to Desktop.

                                                You will find a *.md5 file after extracting.

Step 3: Download and extract Odin on you pc

Click Here  Download Odin v3.10.7. After Downloading ,extract  it to your preferred location in your computer

After extracting, right-click to "Open as Administrator". It may prevent certain issue from happening.

Step 4: Boot your Samsung into safe mode or Download mode

Follow these steps to enter Download Mode/Odin Mode

1. Power off your device
2. Press and hold Volume Down key, Home Key and Power Key
3. When your device vibrates, release Power key while keep holding the Volume Down key and Home key.

(Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading. Do not turn off target )

Step 5: Connect your phone to the computer.

  

You device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says "Added!" and in the meantime you should see a light-blue box at the ID:COM section stating "COM:3" (the number depend on which USB port you have plugged the device cable and is irrelevant).

Step 6: PDA or Ap to Add tar.md5 file

                

                                After adding the file, click "Start" to begin the flashing process.

WARNING DO NOT REMOVE OR OPERATE ON YOUR DEVICE UNTIL FINISHED OR FAILED IS SHOWED ON ODIN.

Ongoing flashing process. Do not remove your device.

When the flashing process is done and if everything goes well, you should see a big green box saying "RESET" or "PASSED" (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device.

                                         comment below if you have any problem with this